Push button Timer

CIS manufacture 3 versions of pushbutton timer.

2031VETR

2 wire design, no neutral required, 10Amp, 254 minutes max duration, N/O contact, best suited to incandescent and mains voltage halogen loads.

instructions

2031VETR3

3 wire design, requires neutral connection, 10Amp, 15 Hours max duration, selectable N/O or  N/C contact, selectable LED ON/OFF with load. Best choice for general switching and very low power loads such as contactors.

instructions

2031VETF

Used to control a light for ON/OFF operation as per normal,  once the light is turned off an internal countdown timer starts.  At the end of the countdown timing operation the Fan is turned off.  
10Amp light, 2 Amp Fan, 10 Minute Max duration timer

instructions

Sunset Switches

CIS manufacture 3 versions of Sunset Switch.

31VSSR

Automatic control based upon ambient light level, Load is turned on when sensor reads approx 50Lux.  2 wire design ( no neutral required ), 10 Amp, 16 hour built-in timer ( allows for "Load ON" at sunset,  "Load OFF" up to 16 hours after sunset).

Instructions

56SSR

Same specification as 31VSSR above.  Enclosed in a 56 Series enclosure for full weather rated external mounting. (IP56)

Instructions

56PEDD3 

3 wire design requiring neutral connection.  Does not support Timing operation as per other units listed above.   This unit is designed as a "back to basics"  Sunset Switch ( 10 Amp ) supplied in 56 Series enclosure as per 56SSR.  (IP56)